Our Services
Heating System Preventive Maintenance
- Check entire furnace for loose or worn parts, abnormal vibrations and proper venting
- Check the heat exchanger, if accessible
- Check electrical circuit to furnace including thermostat and thermostat wiring
- Check gas valve operation, adjust gas pressure if needed. Check, clean & adjust pilot burner as needed
- Check and clean air filter
- Check ignition system
- Check and lubricate blower motor, clean blower wheel if needed
- Check carbon monoxide emission level
- Check electrical/safety circuits for proper operation
- Operate furnace and adjust for peak operating efficiency
Service Tips
There are many things that could be wrong with your system, but give these suggestions a try:
If your system will not come on, check your circuit breakers and disconnect switch.
Changing your thermostat rapidly may cause the compressor motor protector to open. When this happens, the compressor will turn off for a short period of time. Allow 15 minutes for compressor to automatically reset itself.
Check your blower compartment door to insure it is closed. The unit will not come on if the door is not completely closed.
Check outdoor condenser for any blockages. Enclosures around your outside unit can interfere with proper operation.
Sometimes you may experience rooms cooler or warmer than others. You can balance airflow to your satisfaction. Simply pull the lever on the registers downward to decrease and upward to increase airflow. Remember, when increasing airflow for one area you decrease in another. It is not uncommon to find the need to change the airflow for each season.
Willow Spring Heating and Air, Inc is BBB Accredited.
